Skip to content

How many RPM is a frequency in hertz?

Multiply hertz by 60 to get revolutions per minute, or enter any frequency.

Result

3,000 rpm

50 hertz equals 3,000 revolutions per minute

  • The other way round: 1 rpm ≈ 0.01667 Hz.

In all units

Revolutions per minute
3,000 rpm
Hertz
50 Hz
Kilohertz
0.05 kHz
Megahertz
5 × 10⁻⁵ MHz
Gigahertz
5 × 10⁻⁸ GHz

Multiply hertz by 60 to get revolutions per minute, or enter any frequency.

How to use

  1. Type the frequency in hertz.
  2. Read the revolutions per minute. For an AC motor the table below shows the speeds by number of poles.

Synchronous motor speed by supply frequency

Frequency (Hz)2 poles (rpm)4 poles (rpm)6 poles (rpm)
10600300200
251,500750500
402,4001,200800
503,0001,5001,000
603,6001,8001,200
875,2202,6101,740

Speed of the rotating field; a loaded motor turns slightly slower.

How it works

A hertz counts cycles per second and rpm counts turns per minute, so Hz × 60 = rpm. 50 Hz is 3,000 rpm and 25 Hz is 1,500 rpm. The factor holds whenever one cycle is one turn: a shaft, a fan, a rotating field. Changing the frequency changes the speed in proportion: half the frequency, half the speed, and 3,000 rpm is 50 Hz.

For an AC motor the supply sets the speed of the rotating field, called the synchronous speed. A two-pole motor turns once per cycle, a four-pole motor half as fast and a six-pole motor a third, as the table shows. Under load the shaft runs a little slower than this.

The slip to avoid is dividing instead of multiplying. For a sensor that gives pulses, divide the pulse frequency by the pulses per revolution before converting: 100 Hz at 2 pulses per turn is 50 turns a second, 3,000 rpm.

Worked example

How many revolutions per minute is 50 Hz?

  1. One hertz is one turn per second, so 60 turns per minute.
  2. 50 Hz × 60 = 3,000 rpm

50 Hz is 3,000 rpm.

Frequently asked questions

How many rpm is 60 Hz?

3,600 rpm for a two-pole motor, 1,800 rpm for a four-pole motor and 1,200 rpm for a six-pole motor.

Why is my motor slower than the table says?

A loaded motor slips behind the rotating field, usually by a few per cent. The table gives the speed of the field.

How do I get rpm from a tachometer pulse signal?

Divide the pulse frequency by the pulses per revolution to get turns per second, then multiply by 60.

Can I use this to set a drive's frequency from a target speed?

Yes, in reverse: divide the speed by 60 for a two-pole motor, and multiply by the number of poles divided by two for the others.

Send feedback