What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
Δv
7.61 km/s
Burning 90 t of propellant at 3.43 km/s (Isp 350 s) gives 7.61 km/s: short of the 7.79 km/s of a low Earth orbit, even before air and gravity losses.
Key values as a table
| Mass ratio | Δv |
|---|---|
| 2 | 2.38 km/s |
| 5 | 5.52 km/s |
| 9.18 | 7.61 km/s |
| 10 | 7.90 km/s |
| 20 | 10.28 km/s |
- Mass ratio
- 9.18
- Exhaust velocity
- 3.43 km/s (Isp 350 s)
- As one stage
- 7.61 km/s
- Propellant
- 90 t
The Tsiolkovsky rocket equation: Δv from the engine and the mass ratio, and why rockets have stages. Drag the point up the curve.
How to use
- Enter the engine's specific impulse in seconds (or its exhaust velocity) and the rocket's mass with full and with empty tanks.
- Choose the number of stages with the same structure share and the payload they carry. More than one stage needs a payload greater than zero.
- Read the Δv against the speeds of a low orbit and of escape, or drag the point along the curve to change the empty mass.
Δv of a 100 t rocket by engine and staging
100 t fuelled, 10 t empty, 1 t payload, split into stages with the same structure share and payload ratio. Low Earth orbit needs about 9.4 km/s including losses.
How it works
A rocket moves forward by throwing propellant backwards. The faster the exhaust leaves and the larger the share of the rocket that is propellant, the more speed it gains. But every bit of extra propellant must itself be lifted and sped up, so the gain flattens out: doubling the propellant does not double the speed. This is called the tyranny of the rocket equation.
Konstantin Tsiolkovsky's equation gives the change in speed: Δv = vₑ · ln(m₀ / m_f), where vₑ is the exhaust velocity, m₀ the mass with full tanks and m_f the mass when the propellant is gone. Engines are often rated by specific impulse Isp in seconds; vₑ = Isp × g₀ with g₀ = 9.80665 m/s². With Isp 350 s (vₑ = 3.43 km/s), 100 t fuelled, 10 t empty and a 1 t payload, Δv = 3.43 × ln(101 / 11) = 7.61 km/s.
Stages beat the logarithm by dropping empty tanks on the way, so later stages do not carry dead weight. With two stages sharing the same structure share and payload ratio, the same rocket reaches 11.4 km/s. The calculator ignores gravity and air drag, which cost a real launch to orbit 1.5 to 2 km/s more than the orbital speed. The equation follows OpenStax University Physics, volume 1, section 9.7 (openstax.org) and NASA Glenn Research Center's Beginner's Guide to Rockets.
Sources
- NASA Glenn: Ideal Rocket EquationUsed for: formula
- OpenStax University Physics vol. 1, §9.7 Rocket PropulsionUsed for: formula
Frequently asked questions
What is a good specific impulse?
Solid rocket motors reach about 250–280 s, kerosene engines about 300–350 s and hydrogen engines about 450 s in vacuum. Ion thrusters exceed 2,000 s but push very gently.
Why do rockets have stages?
Once a stage's tanks are empty, carrying them on is wasted effort. Dropping them lets the next, smaller stage start with a fresh, high mass ratio, so the Δv of the stages adds up.
How much Δv does it take to reach orbit?
A low circular orbit needs about 7.8 km/s of speed, and the climb through gravity and air costs extra, so launchers are designed for roughly 9.3–10 km/s in total.
Does the rocket push against the air?
No. It pushes against its own exhaust, which is why rockets work best in the vacuum of space, where there is no air to slow them down.
What is the rocket equation?
Tsiolkovsky's equation: Δv = vₑ · ln(m₀ ÷ m_f). The speed gained grows with the exhaust speed and only with the logarithm of the mass ratio, which is why fuel mass must be so large.
Next you might need
More in Astronomy
- Cosmic calendar, private, runs on your device
- Drake equation calculator, private, runs on your device
- Interstellar trip time, private, runs on your device
- Light travel time calculator, private, runs on your device
- Light-speed delay calculator, private, runs on your device
- Mars time, private, runs on your device





