Skip to content

How much force does it take to go round a curve?

Centripetal acceleration and force, lap time and banking angle for anything moving on a circle, with the vectors drawn live.

Centripetal force

5,787 N

At 50 km/h on a 50 m radius it accelerates towards the centre at 3.86 m/s² (0.39 g), which takes a force of 5,787 N.

Acceleration to the centre
3.86 m/s² (0.39 g)
One lap
22.6 s
Ideal banking angle
21.5°
Grip needed on a flat curve (μ)
0.39

Centripetal acceleration and force, lap time and banking angle for anything moving on a circle, with the vectors drawn live.

How to use

  1. Enter the speed and the radius of the circle or curve, or drag the tip of the velocity arrow.
  2. Enter the mass to get the force, for example a car's mass for a curve on the road.
  3. Read the centripetal force and acceleration, the lap time, and the banking angle and grip a road would need.

Centripetal acceleration (m/s²) by speed and curve radius

Speed (km/h)Radius 25 mRadius 50 mRadius 100 m
302.81.40.7
507.73.91.9
7015.17.63.8
902512.56.3

How it works

Anything moving on a circle keeps changing direction, even at a steady speed, so it is always accelerating, towards the centre. Something has to pull it inwards: the string of a swung ball, the grip of the tyres on a curve, gravity for the Moon. That pull is the centripetal force.

The acceleration is a = v² ÷ r and the force F = m·v² ÷ r, with v the speed, r the radius and m the mass. A 1500 kg car taking a 50 m curve at 50 km/h (13.9 m/s) accelerates at 13.9² ÷ 50 ≈ 3.86 m/s², about 0.39 g, and needs 1500 × 3.86 ≈ 5.8 kN of grip. Because the speed is squared, twice the speed takes four times the force, which is why speed limits drop on tight curves.

On a flat curve all of that comes from friction, so the tyres need a friction coefficient of at least v² ÷ (r·g). A banked road tilts the normal force inwards; at tan θ = v² ÷ (r·g) the bank alone is enough. These are the steady-state formulas of OpenStax University Physics, volume 1, section 6.3 (openstax.org); they ignore drag and treat the body as a point.

Frequently asked questions

Is centrifugal force real?

In a rotating reference frame, centrifugal force accounts for the apparent outward push. In a stationary frame, the net force needed for circular motion points inward.

Should I enter the radius or the diameter?

Enter the radius, measured from the centre of the turn to the path. If you know the diameter, divide it by two.

Can I use this for a vertical loop?

It gives the net inward force required at a given speed, but not the seat force or string tension. In a vertical loop, gravity contributes differently at different positions and speed may change.

Can I enter revolutions per minute?

The input is linear speed, not rpm. Convert first using v = 2πr × rpm ÷ 60, with radius in metres to get metres per second.

Does the banking angle give a safe road speed?

No. It describes an ideal steady turn without needing friction; real grip, road surface, tyres and vehicle stability are not assessed.

Send feedback