What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
Longest exposure (NPF rule)
13.9 s
Stars stay sharp for exposures up to 13.9 s (NPF rule); the older 500 rule gives 25 s, which can already trail on a high-resolution sensor.
- 500 rule
- 20.8 s
- Pixel size
- 6 µm
- Full-frame equivalent focal length
- 24 mm
The longest exposure for sharp stars from your lens, aperture and sensor, by the NPF rule and the 500 rule.
How to use
- Enter the real focal length of your lens in millimetres and its f-number.
- Choose your sensor size and enter its resolution in megapixels.
- Read the longest exposure for pin-sharp stars, then set the declination of the sky you point at.
Longest exposures for a 24-megapixel full-frame camera at f/2.8
| Focal length (mm) | 500 rule | NPF rule |
|---|---|---|
| 14 | 35.7 s | 19.9 s |
| 20 | 25 s | 13.9 s |
| 24 | 20.8 s | 11.6 s |
| 35 | 14.3 s | 7.94 s |
| 50 | 10 s | 5.56 s |
| 85 | 5.88 s | 3.27 s |
The NPF rule asks for shorter exposures, especially with long lenses.
How it works
The Earth turns, so stars slide across your camera's sensor during a long exposure and turn into short streaks. To photograph them as points, whether for the Milky Way or the northern lights, the shutter must close before a star moves by more than a pixel or so. A longer lens magnifies the motion and a sensor with smaller pixels shows it sooner, so both shorten the time you have.
The classic 500 rule gives t = 500 / (focal length × crop factor): 500 / 24 = 21 seconds for a 24 mm lens on a full-frame camera. It ignores the sensor's resolution, so on modern high-resolution cameras it often produces trails. The NPF rule includes it: t = (35 × N + 30 × p) / f, where N is the f-number, p the pixel size in micrometres and f the focal length in millimetres. With f/2.8 and 6 µm pixels, that gives (98 + 180) / 24 = 11.6 seconds. Stars near the celestial pole move more slowly, so both times are divided by the cosine of the declination.
These are guides for viewing at normal size; stars viewed at 100 % zoom or in large prints need a shorter time. The pixel size is estimated from the sensor width and megapixels, so a camera with a different aspect ratio or crop mode may differ slightly. Sources: Frédéric Michaud's NPF rule (2010) and Wikipedia on star trails.
Sources
- PhotoPills: NPF ruleUsed for: formula
- Wikipedia: Star trailUsed for: formula
Frequently asked questions
Why is the NPF rule shorter than the 500 rule?
The 500 rule dates from film and low-resolution cameras. Modern sensors have small pixels that show a streak sooner, and the NPF rule accounts for that and for the lens aperture.
What shutter time do aurora photographers use?
Auroras move and change, so 3 to 15 seconds is typical. Use the NPF time as an upper limit for the stars and shorten it when the aurora is bright and fast.
Does the declination matter?
Yes. At the celestial equator stars move fastest on the sensor, which is the worst case; looking toward Polaris, at declination about 89°, they barely move, and the allowed time grows by 1 / cos(declination).
What if I use a star tracker?
A tracker cancels the Earth's rotation, so these limits no longer apply to the stars, only to the foreground, which stays blurred beyond them.
What focal length do I enter on a crop sensor?
The real focal length printed on the lens. The tool applies the sensor's crop factor itself and shows the full-frame equivalent.
Next you might need
More in Astronomy
- Cosmic calendar, private, runs on your device
- Interstellar trip time, private, runs on your device
- Light travel time calculator, private, runs on your device
- Mars time, private, runs on your device
- Meteor shower calendar, private, runs on your device
- Orbital speed calculator, private, runs on your device





