Is your guitar in tune?
Pluck a string and see the note and how far off it is. Standard tuning E A D G B E.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
Tuner
Note
Not listening
Press Start listening and allow the microphone, then play one steady note.
The standard is 440 Hz; some orchestras tune a little higher.
- E2
- 82.4 Hz
- A2
- 110 Hz
- D3
- 146.8 Hz
- G3
- 196 Hz
- B3
- 246.9 Hz
- E4
- 329.6 Hz
Pluck a string and see the note and how far off it is. Standard tuning E A D G B E.
The note and its needle now fill a large live screen; press Space to start or stop listening.
How to use
- Press Start listening, allow the microphone and pluck the thickest string (the 6th, E2) on its own.
- Read the note and the meter. Tighten the string if the needle is left of the middle, loosen it if it is right, until it says In tune.
- Move up through A2, D3, G3, B3 and E4, one string at a time, and check the low E again at the end.
Standard guitar tuning: open strings
| String | Note | Frequency (Hz) |
|---|---|---|
| 6 | E2 | 82.41 |
| 5 | A2 | 110.00 |
| 4 | D3 | 146.83 |
| 3 | G3 | 196.00 |
| 2 | B3 | 246.94 |
| 1 | E4 | 329.63 |
A4 = 440 Hz. String 6 is the thickest and lowest.
How it works
Standard guitar tuning is E2 A2 D3 G3 B3 E4, from the thickest string to the thinnest. Neighbouring strings are a fourth apart (five semitones), except G to B, which is a major third (four semitones). The table lists each open string's frequency at A4 = 440 Hz; the two E strings are two octaves apart, so the high one vibrates four times as fast.
That single major third explains the old fret trick: pressing a string at the fifth fret gives the pitch of the next open string, except on the G string, where the fourth fret matches the open B. If two strings sound out of step with each other, that is a quick check that works without any tuner.
Pluck one string at a time with the others damped and let it ring for a moment: a fresh pluck is often briefly sharp before it settles. Other tunings such as drop D simply lower one string, here the 6th by a whole tone to D2; the chromatic tuner shows any note, so it works for those.
Worked example
The low string sounds at 84 Hz. How far is it from E2?
- Target for E2: 82.41 Hz at A4 = 440 Hz.
- Ratio: 84 ÷ 82.41 = 1.0193.
- Cents: 1200 × log₂(1.0193) = 33.1.
33.1 cents sharp: loosen the string a little until the needle sits in the middle.
Sources
- de Cheveigné and Kawahara: YIN, a fundamental frequency estimator for speech and music (JASA, 2002)Used for: formula
- ISO 16:1975: Acoustics, standard tuning frequency (standard musical pitch)Used for: constants
- Wikipedia: Bass guitarUsed for: reference data
- Wikipedia: Guitar tuningsUsed for: reference data
- Wikipedia: UkuleleUsed for: reference data
- Wikipedia: ViolinUsed for: reference data
Frequently asked questions
What is standard guitar tuning?
From the lowest string to the highest: E2, A2, D3, G3, B3, E4 (E A D G B E), with A4 at 440 Hz.
Which string is the 1st and which the 6th?
The thinnest, highest string is the 1st (E4) and the thickest, lowest is the 6th (E2). Tuning usually starts with the 6th.
Why does the tuner show a different string than I plucked?
It compares the sound with the open string it is closest to. A string that is far too slack can be closer to its lower neighbour, so tighten it a little first and read again.
Why does the tuner need my microphone?
It listens to the string and works out the pitch on your device. Nothing is recorded or sent anywhere.





