Skip to content

How much weaker is light or sound farther away?

Intensity at a new distance from a point source: twice as far, a quarter as strong.

Start from

m

Intensity at 2 m

25

2 m is 2 times as far as 1 m, so the intensity is 25% of it: 100 becomes 25.

Key values as a table
DistanceIntensity thereShare
0.5 m400400%
1 m100100%
2 m2525%
3 m11.111.1%
4 m6.256.3%
5 m44%
10 m11%
Share of the known intensity
25%
Change in level
−6 dB

Intensity at a new distance from a point source: twice as far, a quarter as strong.

How to use

  1. Enter an intensity you know and the distance it was measured at, in any unit: lux, W/m², counts per second, a dose rate.
  2. Enter the new distance, or drag either point along the curve.
  3. To start from a lamp's or speaker's power in watts instead, choose Source power.

Intensity at a multiple of the first distance

Distance (× first)Intensity leftChange (dB)
225%−6
311.1%−9.5
54%−14
101%−20

How it works

A small source that shines or sounds equally in all directions spreads its power over a growing sphere. The sphere's surface grows with the square of its radius, so the same power is shared over four times the area at twice the distance, nine times at three times the distance, and so on.

That gives I = P ÷ (4πr²), and for two distances I₂ = I₁ × (r₁ ÷ r₂)². A reading of 100 at 1 m becomes 100 × (1 ÷ 2)² = 25 at 2 m, a quarter. In decibels every doubling of distance is about −6 dB. A 100 W source gives 100 ÷ (4π × 2²) ≈ 2.0 W/m² at 2 m (OpenStax University Physics, volume 1, sections 16.4 and 17.3).

The law holds for a point source in open space: light from a bulb, sound outdoors, gamma rays from a small radioactive sample, and gravity. It does not hold close to a large source (a long tube light, a wall of speakers), for a beam such as a laser or a spotlight, or where walls reflect and the air absorbs.

Frequently asked questions

Where should I measure the distance from?

Measure from the source to the point where the reading is taken, using the same distance unit for both readings. Measuring from a housing or wall instead can make a large difference close to the source.

Can I enter a lamp’s electrical wattage as source power?

Only if it is the emitted power you want to model. Electrical input power includes losses and is not the same as emitted light or sound power.

How does distance help with radiation safety?

For a small source the dose rate falls with the square of the distance, so stepping from 1 m to 3 m cuts it to about a ninth. Time, distance and shielding are the three rules of radiation protection.

Does a flashlight or laser follow the inverse-square law?

Only far from it. A beam is focused into a narrow cone, so its intensity falls much more slowly than a bare bulb's at short range.

Can I enter a sound level in dB as the known intensity?

No. Enter a linear intensity, such as W/m², in the known-intensity field. Add the reported change in dB to a known sound level to estimate the level at the new distance.

Send feedback