How much filament is on my spool?
Convert filament mass and length using diameter and material density.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
Filament length
333 m
333 m of 1.75 mm filament weighs 1,000 g at 1.25 g/cm³, without the spool.
- Filament mass
- 1,000 g
- Mass per metre
- 3.01 g/m
Formula
m = ρ × π × (d / 2)² × L
Convert filament mass and length using diameter and material density.
How to use
- Choose whether to calculate length from mass or mass from length.
- Enter the net filament amount and diameter.
- Choose a density example or enter a custom value from the filament supplier.
How it works
Treat uniform round filament as a cylinder. Mass m equals density ρ multiplied by cross-sectional area π(d/2)² and length L. The calculation converts millimetres and metres into centimetres so density can be entered in g/cm³.
Material examples are approximate product values, not universal polymer constants. PLA uses the midpoint 1.25 of the supplier’s 1.20–1.30 range. Additives, foaming, moisture and diameter variation change the result. Cost and infill-based print weight are not included.
Worked example
What does the default scenario give?
- Use calculate length, net filament mass 1000 g, filament diameter 1.75 mm, material density example pla.
- Apply m = ρ × π × (d / 2)² × L.
The primary result is 333 m.
Sources
- Fused Materials: Filament Fact SheetUsed for: reference data
- OpenStax College Physics 2e, §11.2 DensityUsed for: definitions
Frequently asked questions
Should I include the spool weight?
No. Subtract the empty spool before entering the net filament mass.
Are all PLA filaments the same density?
No. The example uses the midpoint of one supplier’s range. Use Custom density for a specific grade.
Why does diameter matter so much?
Cross-sectional area depends on diameter squared, so a small diameter difference changes mass per metre.
Does infill change this conversion?
No. This converts solid filament before extrusion; model infill is a separate print-planning input.
Can I use filled or foaming filament?
Use a supplier density relevant to that product, but expect uncertainty if the filament structure or extrusion changes volume.





