How much liquid is in my tank?
Capacity and partial fill for rectangular and cylindrical tanks.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
Liquid volume
785.4 L
Liquid 0.5 m deep, measured vertically from the bottom of the inside.
- Full capacity
- 1,571 L
- Remaining space
- 785.4 L
- Volume filled
- 50%
Formula
V = cross-sectional liquid area × tank length
Capacity and partial fill for rectangular and cylindrical tanks.
How to use
- Choose a horizontal cylinder, vertical cylinder or rectangular tank.
- Enter internal dimensions in metres. For a vertical cylinder, axial length is its height.
- Measure liquid depth from the bottom, then read filled volume and remaining space.
How it works
A rectangular tank holds length × width × depth. A vertical cylinder holds πr²d. For a horizontal cylinder, the liquid cross-section is a circular segment: A = r² acos((r−d)/r) − (r−d)√(2rd−d²), then V = A × L. Here r is the internal radius, d is liquid depth and L is the axial length.
Assumes a level tank with flat ends and constant cross-section. Dished ends, domes, cone bottoms, tilt, wall thickness and expansion are excluded. No printable calibration chart is included.
Worked example
What does the default scenario give?
- Use tank shape horizontal, axial length / vertical cylinder height 2 m, internal diameter 1 m, liquid depth from bottom 0.5 m.
- Apply V = cross-sectional liquid area × tank length.
The primary result is 785.4 L.
Sources
- Wolfram MathWorld: Circular SegmentUsed for: formula
Frequently asked questions
Is half the depth always half the volume?
It is for a rectangular or vertical cylindrical tank. A horizontal cylinder is nonlinear, though its halfway depth is also half its volume.
Should I measure outside dimensions?
Use internal dimensions. Outer dimensions would include the tank walls.
Where is the depth measured?
Vertically from the lowest inside point to the liquid surface.
Does this include rounded ends?
No. The cylindrical model has flat ends; rounded or dished heads need a different volume model.
Does remaining space mean safe usable capacity?
It is only geometric capacity minus liquid volume. Required freeboard and operating limits are outside this calculation.





