How level is your surface?
Lay your phone on a shelf, floor or worktop, or stand it against a wall, to see the tilt in degrees. Readings stay on your device.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
Level
Typed angle
2°
A slope of 3.5%, 35 mm of rise per metre
Press Start and, if asked, allow motion access. Nothing is stored or sent.
For a computer without sensors. Positive means the right side is lower; negative means the left side is lower.
- Slope
- 3.5%
- Rise per metre of run
- 35 mm
Lay your phone on a shelf, floor or worktop, or stand it against a wall, to see the tilt in degrees. Readings stay on your device.
The angle now fills a large live screen, with Start, Hold and Zero on one bar and the typed angle underneath.
How to use
- Press Start level and allow motion access if your phone asks.
- Lay the phone flat on the surface, or choose On edge and stand it against the wall, frame or pipe.
- Read the angle. The bubble sits toward the high side; the card says Level when it is within half a degree.
- To measure a surface that is meant to slope, press Zero on this surface on a surface you trust, then move the phone. Hold reading freezes the number.
- On a computer, type an angle to turn it into a slope in percent and millimetres per metre.
Common tilts as a slope
Slope is 100 × tan of the angle.
How it works
A phone knows which way is down from its motion sensors, which feel gravity. The level takes that direction and works out how far the screen is from horizontal, then draws a bubble that drifts toward the high side like the bubble in a spirit level.
The tilt is the angle θ between the screen and the horizontal. A slope is the same thing written as rise over run: percent = 100 × tan θ. A tilt of 2° is a slope of 3.5%, or about 35 mm of rise over one metre. Sensors are good to roughly half a degree, so use a real spirit level for work that must be exact.
Phone cases, bumps and a warm sensor all add error. Put the phone on the surface the same way up each time, use Zero on this surface on a surface you know is flat, and check a reading by turning the phone around: it should show the same angle.
Method
No outside data is used: the result is worked out directly from the formula s = 100 × tan θ, explained under How it works.
Frequently asked questions
Is my motion data stored or sent?
No. The sensor readings are used on your device to draw the bubble and are never stored, logged or put in the address.
Why does it say not available on this device?
Computers and some browsers have no tilt sensor. Use a phone or tablet, or type an angle in the box below.
How accurate is a phone level?
Usually within about half a degree after zeroing on a flat surface. That is fine for hanging a shelf or checking a camera, not for precision machining.
How do I calibrate it?
Lay the phone on a surface you know is level, press Zero on this surface, then turn the phone around and check that it still reads level.
What is the difference between flat and on edge?
Flat measures how far the whole screen is from horizontal. On edge is for a phone standing against a wall or frame: it reads how far its horizontal side is from level.
How do I turn degrees into a percent slope?
Take the tangent of the angle and multiply by 100. For 2° that is 3.5%; type the angle below to see it.
Next you might need
More in Everyday
- Depth of field, private, runs on your device
- Discount calculator, private, runs on your device
- E-numbers, private, runs on your device
- Exposure value and equivalent settings, private, runs on your device
- Final exam grade calculator, private, runs on your device
- GPA calculator, private, runs on your device





