Skip to content

How much easier do pulleys make a lift?

Block and tackle: the pull to lift a load, the mechanical advantage and the rope you haul in, with the rope segments drawn and counted live.

%

Pull needed

245 N

Pull with 245 N to lift 981 N, like holding 25 kg: to raise it 1 m you haul in 4 m of rope.

Key values as a table
QuantityValue
Supporting segments4
Pulleys2 fixed, 2 moving
Weight of the load981 N
Pull needed245 N
Rope to pull4 m
Mechanical advantage
4×
Feels like holding
25 kg
Rope to pull
4 m
Work in / out
981 J / 981 J

Block and tackle: the pull to lift a load, the mechanical advantage and the rope you haul in, with the rope segments drawn and counted live.

How to use

  1. Count the rope segments that hold up the moving block, the strands between the pulleys, and enter that number.
  2. Enter the load and how high to lift it, or drag the load up in the drawing.
  3. Read the pull you need, the mechanical advantage and the rope to haul in; set the efficiency to include friction.

Lifting 100 kg by 1 m without friction

Rope segmentsPull (N)Rope pulled (m)
19811
24902
33273
42454
61636

How it works

A pulley that hangs from the ceiling only turns the pull around. Pulleys that move with the load share it out: every rope segment holding the moving block carries the same tension, the force you pull with. With n segments holding up a load of weight W, each carries W ÷ n, so the ideal mechanical advantage is n.

Nothing is free: to raise the load by h, each of the n segments has to shorten by h, so you pull n × h of rope. Lifting 100 kg (981 N) with four segments takes 981 ÷ 4 ≈ 245 N, and raising it 1 m means hauling 4 m of rope. Work in, 245 N × 4 m, equals work out, 981 N × 1 m. Friction in the pulleys means you need a little more: the efficiency η divides the pull, effort = W ÷ (n·η).

The rope and pulleys are taken as weightless and the segments as vertical. Based on OpenStax College Physics 2e, section 9.5 (openstax.org).

Frequently asked questions

How do I count the supporting segments?

Count the strands of rope that go into the moving block or are tied to it. Leave out the free end you pull, unless it also leaves the moving block.

Does a single fixed pulley make lifting easier?

It does not reduce the force: the advantage is 1. It only lets you pull down instead of up, so you can use your body weight.

Why not use 20 pulleys?

Each pulley adds friction and rope to pull, so the real advantage grows less than the count, and you must haul ever more rope for each centimetre of lift.

What efficiency is realistic?

Good ball-bearing pulleys lose only a few percent each; plain sheaves with a stiff rope can lose ten percent or more per pulley.

Does the efficiency setting apply to each pulley or the whole system?

It applies to the whole system. Enter one overall efficiency, including all pulley and rope losses, rather than the efficiency of a single sheave.

Send feedback