How much of the power does real work?
The power triangle of an AC load: watts, vars and volt-amperes, the power factor and the capacitor that corrects it. Drag the triangle's tip.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
More options
Real power
1.84 kW
Of the 2.3 kVA the supply delivers, a power factor of 0.8 turns 1.84 kW into work; 1.38 kvar only flows back and forth.
Key values as a table
| Quantity | Value |
|---|---|
| Real power | 1.84 kW |
| Reactive power | 1.38 kvar |
| Apparent power | 2.3 kVA |
| Phase angle φ | 36.9° |
- Apparent power
- 2.3 kVA
- Reactive power
- 1.38 kvar
- Phase angle φ
- 36.9°, lagging
- Capacitor for 0.95
- 775 var (current falls to 8.42 A)
The power triangle of an AC load: watts, vars and volt-amperes, the power factor and the capacitor that corrects it. Drag the triangle's tip.
How to use
- Enter the voltage and the current the load draws, its power factor and whether it is inductive (lagging) or capacitive (leading).
- Read the real power, which does the work, beside the apparent and reactive power; drag the tip of the triangle to try another power factor.
- Under More options, switch to three-phase or change the power factor a correction capacitor should reach.
Power factor, real and reactive power at 230 V and 10 A
| Power factor | Real power (kW) | Reactive power (kvar) | Phase angle (°) |
|---|---|---|---|
| 0.60 | 1.38 | 1.84 | 53 |
| 0.70 | 1.61 | 1.64 | 46 |
| 0.80 | 1.84 | 1.38 | 37 |
| 0.90 | 2.07 | 1.00 | 26 |
| 0.95 | 2.19 | 0.72 | 18 |
| 1.00 | 2.30 | 0.00 | 0 |
The apparent power stays 2.3 kVA; only the share that does work changes.
How it works
In an AC circuit the current does not always rise and fall in step with the voltage. Motors and other coils make it lag behind, capacitors make it lead. Out of step, part of the energy only sloshes back and forth between the supply and the load every cycle, doing no work but still loading the wires. The power factor says how much of the current is useful.
The apparent power is S = V × I in volt-amperes (√3 × V × I for three-phase, with V between two lines). The real power is P = S × cos φ in watts, and the reactive power Q = S × sin φ in volt-amperes reactive (var), where φ is the phase angle between voltage and current and cos φ the power factor. They form a right triangle, S² = P² + Q². A motor drawing 10 A at 230 V with a power factor of 0.8 takes 2.3 kVA but uses 1.84 kW; Q = 2.3 × 0.6 = 1.38 kvar.
A capacitor in parallel supplies the reactive power locally, so the line current falls: to go from cos φ₁ to cos φ₂ it needs Q = P × (tan φ₁ − tan φ₂). The calculation assumes sinusoidal voltages and currents (no harmonics) and, for three-phase, a balanced load. Based on OpenStax University Physics, volume 2, section 15.4 (openstax.org) and Wikipedia's article on power factor.
Sources
- OpenStax University Physics, vol. 2, §15.4 Power in an AC CircuitUsed for: formula
- Wikipedia: Power factorUsed for: formula
Frequently asked questions
Why does a low power factor matter if I only pay for kWh?
Homes usually pay only for real energy, but the wires, fuses and transformers must carry the full current. Businesses are often charged for reactive power or a low power factor for that reason.
What is the difference between kW and kVA?
kW is the real power that does work or makes heat; kVA is voltage times current. Generators, UPS units and transformers are rated in kVA because the current heats them whatever the power factor.
Can the power factor be above 1?
No. The real power can never exceed voltage times current, so cos φ is at most 1, reached by a purely resistive load such as a kettle or heater.
What does three-phase change?
For a balanced load the apparent power is √3 × V × I with V the voltage between two lines (400 V in much of Europe). The power factor and the triangle work the same way.
How do I correct a poor power factor?
Connect capacitors in parallel with the load: they supply the reactive power that the motor would otherwise draw from the grid. The tool shows the kvar to fit and the current you save.
Next you might need
More in Electronics & cabling
- Battery sizes, private, runs on your device
- E-series preferred values, private, runs on your device
- LED resistor calculator, private, runs on your device
- Logic gates, private, runs on your device
- RC circuit calculator, private, runs on your device
- Resistor colour code calculator, private, runs on your device





