How fast will it go after the drop?
Potential and kinetic energy, the work of gravity and the energy lost to friction along a drop, with energy bars that change as you drag the car.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
More options
Speed at 10 m
67.6 km/h
Gravity has done 98.1 kJ of work on the way down to 10 m; 9.81 kJ of it went to friction, the rest is speed: 67.6 km/h, and 82.8 km/h at the bottom.
Key values as a table
| Energy | Amount |
|---|---|
| Height | 49 kJ |
| Motion | 88.3 kJ |
| Lost | 9.81 kJ |
| At the start | 147 kJ |
- Kinetic energy
- 88.3 kJ
- Work done by gravity
- 98.1 kJ
- Average power over 3 s
- 32.7 kW
- Speed at the bottom
- 82.8 km/h
Potential and kinetic energy, the work of gravity and the energy lost to friction along a drop, with energy bars that change as you drag the car.
How to use
- Enter the mass and the height it starts from.
- Set the height it has come down to, or drag the car along the hill, and how much of the energy friction leaves.
- Read its speed there and watch the energy bars: height energy turns into motion, and friction takes its share.
How it works
Lifting something stores energy in its height, the potential energy m·g·h, with m the mass, g the gravitational acceleration and h the height. On the way down gravity does work, W = m·g·Δh, and that energy turns into motion, the kinetic energy ½·m·v². Friction and air drag take a share and turn it into heat, but the total always adds up to what it started with.
A 500 kg roller-coaster car starting at rest 30 m up has 500 × 9.81 × 30 ≈ 147 kJ. Down at 10 m it has dropped 20 m, so gravity has done 98 kJ of work; if 90 % of that becomes speed, ½ × 500 × v² = 88 kJ gives v ≈ 18.8 m/s, about 68 km/h. Power is work per time: 98 kJ in 3 seconds is about 33 kW.
The speed does not depend on the shape of the track, only on the height dropped and the losses, here taken as one share of the drop. Based on OpenStax University Physics, volume 1, chapters 7 and 8 (openstax.org).
Worked example
How much energy does a 500 kg load hold 30 m up, and how fast is it moving when it reaches the ground?
- E = m · g · h = 500 × 9.80665 × 30 = 147.1 kJ.
- If 90% of it becomes motion: ½ m v² = 90% × E, so v = 23 m/s (83 km/h).
147.1 kJ, arriving at 23 m/s.
Sources
- OpenStax University Physics, vol. 1, §8.3 Conservation of EnergyUsed for: formula
Frequently asked questions
Does a heavier car go faster down the hill?
Not in this model when starting speed, height and efficiency are the same. Mass scales the energy and inertia equally, leaving speed unchanged.
Can a car climb higher than its starting height?
It can if it has enough initial kinetic energy or receives energy from a motor. A car starting from rest without added energy cannot exceed its starting height.
Does the time input change the speed?
No. Time is used only to calculate average power from the work done by gravity; speed comes from the energy balance.
Does efficiency also reduce the starting kinetic energy?
No. Here efficiency applies only to the gravitational energy released during the drop; the initial kinetic energy is kept.
Can I use this for a rolling ball?
It does not include energy stored in rotation. A rolling ball can therefore have a lower forward speed than this point-body model predicts.
Next you might need
More in Physics
- Artificial gravity calculator, private, runs on your device
- Black hole time dilation, private, runs on your device
- Blackbody radiation calculator, private, runs on your device
- Buoyancy calculator, private, runs on your device
- Colour mixing: light and paint, private, runs on your device
- Cooling calculator, private, runs on your device





