How much pressure does each gas in a mixture exert?
Dalton's law: the partial pressure of each gas from its share of the mixture.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
More options
Partial pressure of O₂
21.2 kPa
O₂ makes up 20.95% of the molecules, so it exerts 20.95% of the total 101.3 kPa.
Key values as a table
| Gas | Mole fraction | Partial pressure (kPa) |
|---|---|---|
| Oxygen O₂ | 20.95% | 21.23 |
| Nitrogen N₂ | 78.08% | 79.11 |
| Argon Ar | 0.93% | 0.9423 |
| Carbon dioxide CO₂ | 0.04% | 0.04053 |
- Nitrogen N₂
- 79.1 kPa (78.08%)
- Argon Ar
- 0.942 kPa (0.93%)
- Carbon dioxide CO₂
- 0.0405 kPa (0.04%)
Dalton's law: the partial pressure of each gas from its share of the mixture.
How to use
- Enter the total pressure of the mixture and pick its unit.
- Choose the gases and enter each one's share in percent by volume; gases 3 and 4, and moles instead of percent, are under More options. Set an amount to 0 to leave the gas out.
- Read each gas's partial pressure, and drag the end of the bar to change the total pressure.
Oxygen in air at lower total pressure
Air is 20.95 % oxygen. The summit of Mount Everest is at roughly 33.7 kPa.
How it works
In a mixture of gases, each gas behaves as if it were alone in the container. Its molecules hit the walls just as often as they would without the others, so each gas contributes its own pressure, its partial pressure, and these add up to the total. This is Dalton's law of partial pressures.
Each gas's share of the pressure is its share of the molecules, the mole fraction: P_i = x_i × P_total, with x_i = n_i ÷ n_total. For gases, percent by volume is the same as mole percent. Dry air is 20.95 % oxygen, so at sea level, 101.325 kPa, oxygen's partial pressure is 0.2095 × 101.325 = 21.23 kPa; at an altitude where the total is 70 kPa it is 14.7 kPa, though the air is still 20.95 % oxygen.
Dalton's law holds exactly for ideal gases and closely for real gases at ordinary pressures; at very high pressures molecules interact and the sum drifts. Percentages need not add up to 100: the shares are always taken of the gases entered. Sources: OpenStax Chemistry 2e, section 9.3; NASA, Earth Fact Sheet (composition of dry air).
Sources
- NASA Earth Fact SheetUsed for: reference data
- OpenStax Chemistry 2e, §9.3 Stoichiometry of Gaseous Substances, Mixtures, and Reactions (Dalton's law)Used for: formula
Frequently asked questions
Should I use gauge pressure or absolute pressure?
Use absolute pressure, measured from a vacuum. If your gauge reads relative to the surrounding air, add the ambient pressure before entering the total.
Why does entering only oxygen give it the whole pressure?
The tool divides each amount by the sum of the amounts entered. Include the other gases in the mixture; a single nonzero gas is treated as a pure gas.
Can I use mass percentages as volume percentages?
No. Gases have different molar masses, so a mass fraction is generally not a mole or volume fraction. Convert the mass amounts to moles first.
What about water vapour in wet gases?
A gas collected over water also holds water vapour at its vapour pressure, about 3.17 kPa at 25 °C. Add water vapour as one of the gases, or subtract its pressure from the total to get the dry gas's pressure.
Can I enter the gases’ masses instead of moles?
Not directly. Divide each mass by that gas’s molar mass first, then select moles and enter the resulting amounts.
Next you might need
More in Chemistry
- Chemical equilibrium calculator, private, runs on your device
- Electron configuration, private, runs on your device
- Empirical formula calculator, private, runs on your device
- Molar mass calculator, private, runs on your device
- Molarity calculator, private, runs on your device
- Periodic table, private, runs on your device





