How many deck boards do I need?
Decking boards, joists and screws or clips for a simple rectangular deck.
What you enter stays on your device while you use this tool. Opening a shared link sends the settings in its address to HowToolbox to prepare the page.
More options
Decking boards to buy
24 boards
12 m² of decking in 21 rows, 1 board of 4.2 m each.
- Joists
- 11 joists of 3 m
- Screws
- 510
- Board and joist crossings
- 231
Decking boards, joists and screws or clips for a simple rectangular deck.
How to use
- Enter the length and width of the deck. The boards run along the length.
- Pick the length of the boards you will buy, and enter the width of one board and the gap between boards.
- Read the boards, joists and fasteners. Under More options, change the joist spacing, choose screws or hidden clips and set the extra for cuts.
Parts for decks with 3 m boards, 140 mm boards and 10 % extra
How it works
The boards of a deck lie side by side across its width. The number of rows is the width divided by the board width plus the gap, rounded up. Each row is as long as the deck, so it takes the length divided by the board length, rounded up, boards laid end to end. The joists run across the width: one every joist spacing along the length, plus the last one. Every board is fixed to every joist it crosses.
Example: a deck 4 m long and 3 m wide with 140 mm boards and 5 mm gaps needs ⌈3 ÷ 0.145⌉ = 21 rows. With 4.2 m boards each row is one board, so 21 boards, or 24 with 10 % extra. Joists every 400 mm along 4 m make ⌊4 ÷ 0.4⌋ + 1 = 11 joists of 3 m. There are 21 × 11 = 231 crossings, and two screws at each, with the extra, are about 510 screws. Hidden clips use one clip at each crossing.
This is a materials estimate for a simple rectangle. It does not include the posts, beams, ledger, fascia, rails or stairs, and it does not check whether the joist size can span the distance or carry the load. Joist size, span, footings and fixings depend on the wood, the load and local building rules, so follow your board maker's installation guide and local code, or ask a builder.
Method
No outside data is used: the result is worked out directly from the formula explained under How it works.
Frequently asked questions
How many deck boards do I need?
Divide the deck width by the board width plus the gap to get the rows, then multiply by the boards each row needs, and add about 10 % for cuts. The calculator does this for you.
How far apart should deck joists be?
Usually 400 mm (16 in) between centres for wooden decking, 300 mm (12 in) for composite boards or diagonal boards. Check the board maker's guide.
How big a gap should I leave between deck boards?
About 5 mm (1/4 in) for most boards, so water drains and the wood can swell. Follow the maker's guidance, which depends on the material and on whether the boards are dry when laid.
How many screws do I need for a deck?
Two screws at every crossing of a board and a joist, so the number depends on the rows and joists. The calculator adds your extra and rounds to ten.
Do I need a permit to build a deck?
Often, if the deck is raised, attached to a house or above a certain size. The rules vary by place, so ask your local building authority before you start.





